Hello all, would like to know how many users are actually writing either KXL and/or CDE code?

Just asking since there has not been a single post in this forum section.

Kind of sad, since there are truly powerful programs to be had and/or made :)

Hans

---

Hi Hans,

Have not programmed for a few years, but I use the functions frequently to save time.

I know you are a master at this programming. My favorite of yours is Level on / off. Thanks for that!

All the best,

Mike

Wow, one person only? That seems hard to believe :(

Thank you Mike!

---

I did quite a bit of programming using CADL in Cadkey and then KXL in KeyCreator, that was mostly back when the original forum was still intact. That forum was a treasure trove of information, it's really too bad none of that information was transferred to the new forum(s). I learned a lot about programming from the original forum, much of it from you Hans, and I certainly appreciate all the help you provided.

I still write an occasional program when a specific need comes up, but that's not often.

George

I would like to learn more about KXL. Is there a document on all the functions available ?

---

Francis,

in my install it's C:\KeyCreatorPro.2025.SP2\Lang\English\kxl.doc or kxl.hlp.

Hans

---

This has been my programming project over the past few years to aid me in injection mold design!

---