Posted by: hans@jennicamolddesign.com - Tuesday, July 14, 2026 3:14:12 PM
Hello all, would like to know how many users are actually writing either KXL and/or CDE code? Just asking since there has not been a single post in this forum section. Kind of sad, since there are truly powerful programs to be had and/or made :) Hans

Posted by: michael@gutmandesign.com - Wednesday, July 15, 2026 2:34:02 PM
Hi Hans, Have not programmed for a few years, but I use the functions frequently to save time. I know you are a master at this programming. My favorite of yours is Level on / off. Thanks for that! All the best, Mike

Posted by: hans@jennicamolddesign.com - Thursday, July 23, 2026 1:15:49 PM
Wow, one person only? That seems hard to believe :( Thank you Mike!

Posted by: George F - Friday, July 31, 2026 2:54:14 PM

I did quite a bit of programming using CADL in Cadkey and then KXL in KeyCreator, that was mostly back when the original forum was still intact. That forum was a treasure trove of information, it's really too bad none of that information was transferred to the new forum(s). I learned a lot about programming from the original forum, much of it from you Hans, and I certainly appreciate all the help you provided. I still write an occasional program when a specific need comes up, but that's not often. George

Posted by: francis.marcoux@ipexna.com - Thursday, September 10, 2026 5:28:22 PM
I would like to learn more about KXL. Is there a document on all the functions available ?

Posted by: hans@jennicamolddesign.com - Thursday, September 10, 2026 6:36:19 PM
Francis, in my install it's C:\KeyCreatorPro.2025.SP2\Lang\English\kxl.doc or kxl.hlp. Hans

Posted by: hans@jennicamolddesign.com - Thursday, September 10, 2026 7:08:30 PM
This has been my programming project over the past few years to aid me in injection mold design! [img]https://res.cloudinary.com/w2m4yxfs/image/upload/f_auto,q_auto/2026-09-10_17-39-45.jpg[/img]

Posted by: francis.marcoux@ipexna.com - Monday, September 14, 2026 4:10:19 PM
Hi Hans ! Very impressive tools you have developped!!! Can these tools be purchased ?

Posted by: hans@jennicamolddesign.com - Tuesday, September 15, 2026 3:52:15 PM
Francis, I sent an email to you. If you didn't get it, feel free to contact me. Hans